Toyota 4-Runner 1985 Repair Manual page 331

CLUTCH - Clutch Unit CL-11
82026
82027
82028 CL0024
MP Grease
82030
CL0016 CL0017
3. CHECK DIAPHRAGM SPRING TIP ALIGNMENT
Using a feeler gauge and SST, measure the gap between
the spring tips and the tool.
SST
09302-30031
Maximum gap: 0.5 mm (O.020 in.)
If the gap is excessive, adjust as follows.
4. IF NECESSARY, ADJUST SPRINGS
Using SST, bend the springs to correct alignment.
SST
09333-00012
5. APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE
GREASE (NLGI NO.2) OR MP GREASE
(a)
Apply molybdenum disulphide lithium base grease to
the following parts:
• Release fork and hub contact point
• Release fork and push rod contact point
• Release fork pivot point
• Clutch disc spline
• Release bearing hub inside groove
(b) Apply MP grease to release bearing.
6. INSTALL BOOT, FORK, HUB AND BEARING ON
TRANSMISSION
7 . INSTALL TRANSMISSION