Toyota 4-Runner 1985 Repair Manual page 502

AT-100
AUTOMATIC TRANSMISSION - Assembly of Transmission
,
34. CHECK OPERATION OF PARKING LOCK PAWL
Make sure the planetary gear output shaft is locked whpl"\
the manual valve lever is in the lip" range.
35. INSTALL NEW a-RING ON THROTTLE CABLE FITTING
36. INSTALL THROTTLE CABLE IN CASE
Push the cable through the case, being careful not to
damage the O-ring. Check for full seating.
CAUTION: In subsequent work, do not roll the case over
the cable and break the cable fitting.
37. INSTALL ACCUMULATOR PISTON AND SPRINGS
Spring mm (in.)
~
E/G
Free length Outer diameter
No Wire diametf' I
B2
22R 66.50 (2.6180) 17.91 (0.7051) 13.5 2.60 (0.102 ....
22R-E 66.68 (2.6252) 16.36 (0.6441) 14.5 2.60 (0.1024)
C2
All 55.18 (2.1724) 15.87 (0.6248)
8.5 2.00 (0.0787)
C,
22R
68.56 (2.6992) 17.53 (0.6902) 15.5 2.03 (0.0800)
22R-E 64.80 (2.5512) 17.20 (0.6772) 13
2.00 (0.0787)
38. PLACE VALVE BODY ON TRANSMISSION
• Make sure the accumulator pistons are pressed fully into
the bore. Align the manual valve with the pin on the manual
valve lever, and lower valve body into place.
39. LIFT SIDE OF VALVE BODY AND ATTACH THROTTLE
CABLE
While holding the cam down by hand, slip the cable end
into the slot.