Toyota 4-Runner 1985 Repair Manual page 427

AUTOMATIC TRANSMISSION - On-Vehicle Repair AT-25
PROOOl
AT0762
3. INSTALL NEW GASKET AND EXTENSION HOUSING ON
TRANSMISSION
Install the six bolts finger tight and then torque them.
NOTE: The two lower bolts are shorter.
Torque: 345 kg-em (25 ft-Ib, 34 N·m)
4. INSTALL ENGINE REAR MOUNTING
5.
(a) Install the engine rear mounting to the extension hous-
ing. Tighten the four bolts.
Torque: 250 kg-em (18 ft-Ib, 25 N·m)
(b) Lower and rest the transmission on the mounting
bracket.
(c) Connect the mounting to the bracket. Tighten the four
bolts.
Torque: 130 kg-em
(9
ft-Ib, 13 N·m)
INSTALL SPEEDOMETER DRIVEN GEAR
(a) Install a new O-ring on the shaft sleeve.
(b) Install the lock plate with a bolt and washer.
6. CONNECT SPEEDOMETER CABLE
Place felt dust protector and washer on the end of the cable.
Tighten the collar with pliers.
7 . INSTALL PROPELLER SHAFT
Torque: 750 kg-em (54 ft-Ib, 74 N
om)
8. LOWER VEHICLE AND CHECK FLUID LEVEL
Start the engine, shift the selector into each gear, then
check the fluid level with the transmission in lip" range.
Add fluid as necessary.
Fluid type: ATF DEXRON II
CAUTION: Do not overfill.