Toyota 4-Runner 1985 Repair Manual page 303

ST-8
SST
Terminal 50
Terminal C
STARTING SYSTEM - Starter
ST0023
(c) Using SST and a hammer, tap a new large bearing onto
the shaft.
SST 09285-76010
(d) Using a press, install a new small bearing onto the
shaft.
Magnetic Switch
1. PERFORM PULL-IN COIL OPEN CIRCUIT TEST
Using an ohmmeter, check for continuity between terminal
50 and terminal C.
If there is no continuity, replace the magnetic switch.
2. PERFORM HOLD-IN COIL OPEN CIRCUIT TEST
Switch Body
Using an ohmmeter, check for continuity between terminal
ST0024
STOO25 STOOl 0
50 and the switch body.
If there is no continuity, replace the magnetic switch
ASSEMBLY OF STARTER
(See page ST -3)
NOTE: Use high-temperature grease to lubricate the bear-
ings and gears when assembling the starter.
1. PLACE ARMATURE INTO FIELD FRAME
Apply grease to the armature bearings and insert the ar-
mature into the field frame.
2. INSTALL BRUSH HOLDER AND BRUSHES
(a) Using a screwdriver or steel wire, hold the brush spring
back, and install the brush into the brush holder. In-
stall four brushes.
NOTE: Make sure that the positive lead wires are not
grounded.
(b) Place the a-ring on the field frame (1.4 kW type only).
(c) Install the end cover to the field frame.