Toyota 4-Runner 1985 Repair Manual page 15

-
~-------
- - - - - - - -
MAINTENANCE -
Maintenance Operations
MA-5
22R Engine 22R-E Engine
Front Back
MA0060 MA0061
Drain Cock
MA0039
3. INSPECT IGNITION WIRING AND DISTRIBUTOR CAP
(a) Remove the distributor cap with the wire.
(b) Clean the distributor cap and wires with a clean cloth.
(c) Visually inspect the wiring for cracks or damage.
(d) Visually inspect the cap for cracks, carbon tracks or
wear.
NOTE: In areas where road salt is used, inspection and
cleaning should be performed each year just after the snow
season.
4. INSPECT AIR FILTER
(a) Visually check that the air cleaner element is not ex-
cessively dirty, damaged or oily.
NOTE: Oiliness may indicate a stuck PCV valve.
If necessary, replace the air cleaner element.
(b) Clean the element with compressed air.
First blow from inside (or back side) thoroughly, then blow
off the outside (or front side) of the element.
5. REPLACE AIR FILTER
Replace the used air cleaner element with a new one.
6. REPLACE ENGINE OIL AND OIL FILTER
(See page LU-3)
Oil grade: API grade SF or SF/CC multigrade, fuel-efficient
and recommended viscosity oil.
Engine oil capacity (Drain and refill with oil filter
change): 4.6 liters (4.9 US qts, 4.0 Imp. qts)
7. REPLACE ENGINE COOLANT
(a) Drain the coolant from the radiator and engine drain
cocks. (Engine drain is at left rear of engine block.)
(b) Close the drain cocks.
(c) Fill system with coolant.
Coolant capacity (w/heater or air conditioner):
8.4 liters (8.9 US qts, 7.4 Imp. qts)
Use a good brand of ethylene-glycol base coolant, mixed
according to the manufacturers instruction.