Entering Enr Data; Selecting A Common Enr Table - Agilent Technologies NFA Series Quick Reference Manual

Figure 2-1
Figure 2-2

Entering ENR Data

You can enter ENR data for the noise source you are using as a table for
measurements at several frequencies, or as a single spot value for
measurements at a single frequency.

Selecting a Common ENR Table

To use the same ENR table for calibration and measurement, press the
menu key set the
Common Table
This is the default setting. In this mode the
Menu Keys showing Common ENR Table Enabled
To use different ENR tables for calibration and measurement, press the
menu key set the
Common Table
In this mode, the
Cal Table
of the noise source used to calibrate the Noise Figure Analyzer. The
is used to make the measurements.
Table
Menu Keys showing Common ENR Table Disabled
Chapter 2
Making Basic Measurements
Common Table(On)
Cal Table
Common Table(Off)
menu key is accessible. This is the ENR table
Entering ENR Data
, see Figure 2-1.
is not accessible.
, see Figure 2-2.
Meas
23