Dmm Module - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

dmm module

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
dmm module
To specify default DMM values for migration block size, number of migration blocks and fast migration
speed, use the dmm module command in configuration mode.
Syntax Description mod-id
rate-of-migration
fast migration-rate
medium migration-rate
slow migration-rate
Defaults
None.
Command Modes Configuration mode.
Command History Release
3.2(1)
Usage Guidelines
None.
Examples
The following example shows how to set the fast migration rate to 100 MB/s, the medium migration rate
to 50 MB/s, and slow migration rate to 10 MB/s:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config) dmm module 3 rate_of_migration fast 100 medium 50 slow 10
Cisco MDS 9000 Family Command Reference
5-38
dmm module mod-id rate-of-migration fast migration-rate medium migration-rate slow
migration-rate
Modification
This command was introduced.
Specifies the module ID.
Migration rate can be configured as slow, medium or fast.
Specifies the rate for fast migration. Units are megabytes per
second (MB/s).
Specifies the rate for medium migration. Units are MB/s.
Specifies the rate for slow migration. Units are MB/s.
Chapter 5 D Commands
OL-18089-01, Cisco NX-OS Release 4.x