Ipv6 Mld Last-Member-Query-Interval - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

ipv6 mld last-member-query-interval

ipv6 mld last-member-query-interval tenthsOfaSecond
Syntax
no ipv6 mld last-member-query-interval
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies in tenths of a second the maximum time the router waits for a response
Description
after sending a last member query. The router sends a last member query when it
receives an MLDv1 leave message or an MLDv2 state change report. The no version
restores the default value, 10 tenths of a second (1 second).
Options
Interface Configuration, Profile Configuration
Mode
tenthsOfaSecond Time interval to wait after sending out of a last member query
in the range 1–254 tenths of a second. Using a lower value allows members to
leave groups more quickly.
Chapter 10: I Commands
ipv6 mld last-member-query-interval
1025