Netscreen-Remote; Network Address Translation (Nat) - Juniper JUNOS OS 10.4 - RELEASE NOTES Release Note

JUNOS OS 10.4 Release Notes
140
On SRX Series devices, in the J-Web interface, there is no support to change the T1
interface to an E1 interface or vice versa. As a workaround, use the CLI to convert from
T1 to E1 and vice versa.
On SRX Series and J Series devices, users cannot differentiate between Active and
Inactive configurations on the System Identity, Management Access, User Management,
and Date & Time pages.
On SRX210, SRX240, and SRX650 devices, the complete contents of the ToolTips are
not displayed in the J-Web Chassis View. As a workaround, drag the Chassis View
image down to see the complete ToolTip.
On SRX210 devices, there is no maximum length when the user commits the hostname
in CLI mode; however, only 58 characters maximum are displayed in the J-Web System
Identification panel.
On J Series devices, some J-Web pages for new features (for example, the Quick
Configuration page for the switching features on J Series devices) display content in
one or more modal pop-up windows. In the modal pop-up windows, you can interact
only with the content in the window and not with the rest of the J-Web page. As a
result, online Help is not available when modal pop-up windows are displayed. You
can access the online Help for a feature only by clicking the Help button on a J-Web
page.
On SRX Series devices, you cannot use J-Web to configure a VLAN interface for an IKE
gateway. VLAN interfaces are not currently supported to be used as IKE
external-interfaces.

NetScreen-Remote

On SRX Series devices, NetScreen-Remote is not supported in Junos OS Release 10.4.

Network Address Translation (NAT)

NAT rule capacity change—To support the use of large-scale NAT (LSN) at the edge
of the carrier network, the device-wide NAT rule capacity has been changed.
The number of destination and static NAT rules has been incremented as shown in
Table 10 on page 140. The limitation on the number of destination-rule-set and
static-rule-set has been increased.
Table 10 on page 140 provides the requirements per device to increase the configuration
limitation as well as scale the capacity for each device.
Table 10: Number of Rules on SRX Series and J Series Devices
NAT Rule
Type SRX100
Source NAT 512
rule
Destination 512
NAT rule
SRX210 SRX2 40 SRX650
512 1024 1024
512 1024 1024
SRX3400 SRX5600
SRX3600 SRX5800 J Series
8192 8192 512
8192 8192 512
Copyright © 2010, Juniper Networks, Inc.