Table 36: Show Gre Tunnel Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Action
Meaning
182
include the name of the tunnel. To display information about tunnels on a specific virtual
router, include the name of the virtual router.
To display information about GRE Tunnel policy lists:
host1#show gre tunnel detail tunnelGre50
GRE tunnel tunnelGre50 is Down
Tunnel operational configuration
Tunnel mtu is '10240'
Tunnel source address is '0.0.0.0'
Tunnel destination address is '0.0.0.0'
Tunnel transport virtual router is source
Tunnel checksum option is disabled
Tunnel sequence number option is disabled
Tunnel up/down trap is enabled
Tunnel-server location is 6/0
Tunnel administrative state is Up
Statistics packets
Data rx 0
Data tx 0
GRE tunnel policy input routeGre25
classifier-group gre6 entry 1
0 packets, 0 bytes
traffic-class best-effort
mark 4 mask 255
GRE tunnel policy output routeGre35
classifier-group gre14 entry 1
0 packets, 0 bytes
traffic-class best-effort
mark 4 mask 255
Table 36 on page 182 lists the show gre tunnel command output fields.

Table 36: show gre tunnel Output Fields

Field Name
GRE tunnel policy input
GRE tunnel policy output
traffic-class
classifier-group
entry
packets
bytes
mark
mask
octets discards
0 0
0 0
Field Description
Policy for outbound traffic
Policy for inbound traffic
Name of traffic class
Name of classifier group
Identifier for the entry in the classifier group
Number of packets
Number of bytes
ToS byte setting for the classifier control list
Mask value corresponding to the ToS
Copyright © 2010, Juniper Networks, Inc.
errors
0
0