Monitoring Detailed Configuration Information About Specified Tunnels - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Table 91: show l2tp switch-profile Output Fields (continued)
Related Topics

Monitoring Detailed Configuration Information about Specified Tunnels

Display detailed configuration information about specified tunnels.
Purpose
To display detailed configuration information about specified tunnel by ip address:
Action
host1#show l2tp tunnel virtual router default ip 172.31.1.98
L2TP tunnel 1/xyz is Up with 13 active sessions
L2TP tunnel 1/aol.com is Up with 13 active sessions
L2TP tunnel 1/isp.com is Up with 13 active sessions
L2TP tunnel 1/msn.com is Up with 13 active sessions
L2TP tunnel 1/mv.com is Up with 12 active sessions
5 L2TP tunnels found
To display detailed configuration information about specified tunnel:
host1#show l2tp tunnel detail 1/xyz
L2TP tunnel 1/xyz is Up with 13 active sessions
Configuration
Tunnel address
Tunnel status
Sub-interfaces
Statistics
Control channel statistics
Field Name
AVP actionType action is
show l2tp switch-profile
Administrative state is enabled
SNMP traps are enabled
Transport ipUdp
Virtual router default
Local address 192.168.1.230, peer address 172.31.1.98
Local UDP port 1701, peer UDP port: 1701
Effective administrative state is enabled
State is established
Local tunnel id is 14529, peer tunnel id is 34
total
Sessions 13
packets
Control rx 14
Control tx 41
Data rx 67900944
Data tx 67900944
Receive window size = 4
Receive ZLB = 17
Receive out-of-sequence = 0
Receive out-of-window = 0
Transmit window size = 4
Monitoring Detailed Configuration Information about Specified Tunnels
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Indicates the tunnel switching behavior or action type
(for example, relay) configured for the specified L2TP
AVP type
active failed
13 0
octets discards
683 0
4666 0
67900944 0
67900944 0
errors
0
0
0
0
445