Monitoring Status And Configuration For Mpls Tunnels - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 59: show mpls rsvp hello instance Output Fields (continued)
Related Topics

Monitoring Status and Configuration for MPLS Tunnels

Display status and configuration for all tunnels or for a specific tunnel in the current
Purpose
router context.
To display the status and configuration for all tunnels:
Action
host1#show mpls tunnels
Tunnel 1 to
Tunnel 2 to
Field Name Field Description
SrcInstance Nonzero 32-bit value that represents the sender's hello instance.
The value is maintained on a per-neighbor basis. This instance
value changes only when the sending peer resets, when the sender's
router reboots, or when communication is lost between the hello
adjacency peers.
DstInstance 32-bit SrcInstance value most recently received from hello
adjacency peer; value is zero when no instance has been received
from that peer
Hellos Sent Number of hello messages sent
Hellos Received Number of hello messages received
Hellos Suppressed Number of hello messages suppressed; message generation is
suppressed when a hello request object is received from the
destination node within the hello interval
Hellos Acks Sent Number of acknowledgments sent in response to hello requests
received
Hellos Acks Received Number of acknowledgments received in response to hello requests
sent
show mpls rsvp hello instance
0.0.0.0
State: Enabled with Incomplete Config
tunnel not announced to any IGP
(Global) Retry forever
at (Global) interval 5 during Lsp setup if there is route
(Global) Retry forever
at (Global) interval 5 during Lsp setup if there is no route
metric is relative 0
222.9.1.3
State: Up
Out label 24 on ATM3/0.1 nbr 10.10.11.5
14 pkts, 0 hcPkts, 2156 octets
0 hcOctets, 0 errors, 0 discardPkts
Monitoring Status and Configuration for MPLS Tunnels
Chapter 4: Monitoring MPLS
365