Figure 89: Configure Gateway Parameters For Autokey Ike Vpn; Figure 90: View Autogenerated Rules For Autokey Ike Vpn - Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
590

Figure 89: Configure Gateway Parameters for AutoKey IKE VPN

Click Save to save your configuration changes to the VPN.
To view the autogenerated rules, click the Policy Rules link in the Overrides section.
VPN Manager generates the rules as shown in Figure 90 on page 590.

Figure 90: View Autogenerated Rules for AutoKey IKE VPN

Add the VPN Link. You must create a VPN link between the Zone rulebase in a security
10.
policy and the VPN Manager autogenerated rules. You create this link by inserting a
VPN link in the zone rulebase; this links points to the VPN rules that exist in the VPN
Manager.
In Security Policies, select an existing security policy (or create a new security policy).
In the Zone rulebase, right-click and select Add VPN link.
Select the Tokyo-Paris Policy-Based VPN, then click OK to add the link. By default,
the link appears at the top of the rulebase, but you can move the VPN link anywhere
in the rulebase, just as you would a firewall rule.
Copyright © 2010, Juniper Networks, Inc.