[188] Ascend-Num-In-Multilink - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

radius include delegated-ipv6-prefix

[188] Ascend-Num-In-Multilink

Use the following command to manage the Ascend-Num-In-Multilink attribute.
radius include ascend-num-in-multilink
radius include delegated-ipv6-prefix
Use to include the Delegated-Ipv6-Prefix attribute in Acct-Start or Acct-Stop
messages.
You can control inclusion of the Delegated-Ipv6-Prefix attribute by enabling or
disabling this command.
For this attribute, the value received from the RADIUS server in the Access-Accept
message is used in the accounting messages.
When prefix delegation occurs, an immediate-update (if enabled) message, which
contains the delegated prefix information, is sent to the RADIUS server.
When the prefix to be delegated to clients is obtained from the IPv6 local address
server than the RADIUS server and the aaa dhcpv6-delegated-prefix
delegated-ipv6-prefix command is configured, the delegated prefix is sent to
the RADIUS server in the Delegated-Ipv6-Prefix attribute in the immediate
accounting, Acct-Stop, or Interim-Acct messages.
When the prefix to be delegated to clients is allocated from the IPv6 local address
server and the aaa dhcpv6-delegated-prefix delegated-ipv6-prefix command
is not configured, the delegated prefix is sent to the RADIUS server in the
Framed-Ipv6-Prefix attribute in the immediate accounting, Acct-Stop, or
Interim-Acct messages.
For static interfaces, although the prefix configured using the CLI command is
used for DHCPv6 Prefix Delegation instead of the value returned by the RADIUS
server, the immediate accounting, Acct-Stop, or Interim-Acct messages contain
the prefix returned from the RADIUS server. If this attribute is not returned from
the RADIUS server, the immediate accounting, Acct-Stop, or Interim-Acct
messages do not report this attribute.
See radius include
Example
host1(config)#radius include delegated-ipv6-prefix acct-start enable
Use the no version to restore the default, disable.
radius include ascend-num-in-multilink
Use to include the Ascend-Num-In-Multilink attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Ascend-Num-In-Multilink attribute by enabling
or disabling this command.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
219