Configuring Cos Schedulers (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

Configuring CoS Schedulers (NSM Procedure)

Table 20: Configuring Schedulers
Task
Specify the buffer size.
Copyright © 2010, Juniper Networks, Inc.
Using schedulers, you can assign attributes to queues and thereby provide congestion
control for a particular class of traffic. These attributes include the amount of interface
bandwidth, memory buffer size, transmit rate, and schedule priority.
To configure CoS schedulers:
In the navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure CoS schedulers.
Click the Configuration tab. In the configuration tree expand Class of Service.
3.
Select Schedulers.
4.
Add or modify the settings as specified in Table 20 on page 31.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Network
and Security Manager Administration Guide for more information.
Action
1. Click the Add New icon.
2. Expand Buffer Size.
3. Select Percent.
4. Under Percent, select the appropriate option:
To specify no buffer size, select None.
To specify buffer size as a percentage of the total buffer, select percent and type an integer
from 1 through 100.
To specify buffer size as the remaining available buffer, select remainder.
5. Click OK.
Chapter 3: Configuring Class of Service
31