Configure Dynamic Arp Inspection - NETGEAR M7100 Series User Manual

From the Interface list, select the interface to add a binding into the IPv6SG database.
8.
Use MAC Address to specify the MAC address for the binding.
9.
Use VLAN ID to select the VLAN from the list for the binding rule.
10.
Use IPv6 Address to specify valid IP address for the binding rule.
11.
Click the Add button.
12.
The IPv6SG static binding entry is added to the database.
To delete the selected static entries from the database, click the Delete button.
13.
To clear all the dynamic binding entries, click the Clear button.
14.
The following table describes the nonconfigurable IPv6 Source Guard Dynamic Binding
Configuration information that is displayed.
Table 226. IPv6 Source Guard Dynamic Binding Configuration
Field
Interface
MAC Address
VLAN ID
IPv6 Address
Filter Type

Configure Dynamic ARP Inspection


To configure dynamic ARP inspection (DAI):
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
1.
example, 169.254.100.201.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
2.
the switch.
M6100, M5300, and M7100 Series Managed Switches
Description
The interface to add a binding into the IPSG database.
The MAC address for the binding entry.
The VLAN for the binding entry.
Displays valid IPv6 address for the binding entry.
Filter type used on the interface. One is source IPv6 address filter type,
and the other is source IPv6 address and MAC address filter type.
Manage Device Security
625