Alcatel Omni Switch/Router User Manual page 564

Creating a New Group
e. The following prompt displays:
Enter a useful description for this virtual IP router port using alphanumeric characters. The
description may be up to 30 characters long. Press
f. The following prompt displays:
Indicate whether you want to disable routing in the group. You can enable routing later
through the
g. The following prompt displays:
Define the
Protocol) is a network-layer protocol that enables the default
and advertise routes. The
. The default setting shown in parentheses.
mation from other
routing information concerning the default
in their routing tables. Simply press
VLAN
.
RIP
updates from other
mation from other
press
.
RIP
Group will receive routing information from other
ing tables of other
.
RIP
this Group will neither send nor receive routing information to/from other
and press
h. If routing domains are not configured on the switch, go to the next step. If routing
domains are configured on the switch, the following prompt displays:
Enter a routing domain in which this group should be included, or press
domain is a grouping of IP router interfaces that can forward packets only within the
domain. Routing domains are part of Advanced Routing software and are not part of the
base code. For more information about routing domains, see Chapter 14, "Routing
Domains," in the Advanced Routing User Manual.
i.
After you enter the RIP mode, or after you enter a routing domain ID, the following
prompt displays:
Page 19-22
command.
mode in which the virtual router port will operate.
RIP
mode can be set to one of the following:
RIP
s, but does not send out
VLAN
is active and sends routing information to other
s. The default
VLAN
s and will not include other
VLAN
to select Deaf mode.
is active and both sends and receives
s. Enter
VLAN
is inactive and neither sends nor receives
to select Inactive mode.
.
is active and receives routing infor-
RIP
updates. Other
RIP
in this Group and will not include the
VLAN
to select Silent mode.
VLAN
in this Group will not receive routing infor-
VLAN
s in its routing table. Enter
VLAN
updates. The default
RIP
s and will be included in the rout-
VLAN
and press to select Active mode.
updates. The default
RIP
(Router Information
RIP
in this Group to learn
VLAN
s will not receive
VLAN
s, but does not receive
in this
VLAN
in
VLAN
s. Enter
VLAN
. A routing
RIP
and