Modifying 802.1Q Groups For Gigabit Ethernet Ports - Alcatel Omni Switch/Router User Manual

Modifying 802.1Q Groups

Modifying 802.1Q Groups for Gigabit Ethernet Ports

To modify the configuration of an
shown:
where
the service was created, and
ple, to modify
If this is a legacy Ethernet module, the screen appears as shown:
If this is a Kodiak ASIC-based module, the screen appears as shown:
To change a field setting, enter the line number, an equal sign, and the new value. For exam-
ple, to change the
equal sign ( ), and a
Page 16-14
802.1Q
is the slot number of the module on the switch,
service instance 1 on port 5 of slot 2, enter:
802.1Q
setting to , you would enter a (the line number for priority), an
, as shown:
o Important Notes o
ESX-K and GSX-K Kodiak ASIC-based modules support
traffic prioritization. For chassis configurations
802.1p
that include only ESX-K, GSX-K and/or WSX series
modules, priority bits can be carried inbound on
802.1p
a tagged port (configured with multiple spanning tree
) across the backplane. This priority information
802.1Q
is used at the egress port to queue the packet, and is
sent out in the packet whether the egress port is tagged
or not.
The ESX-K and GSX-K modules can also remap incom-
ing priority on an ingress port. If priority remapping
has been configured, the new priority will be carried
across the backplane. The priority information is used
to queue the packet, and is sent out in the packet if the
egress port is tagged.
group for Gigabit ports, use the
is the identifier for the service on this port. For exam-
command as
is the port number where