Alcatel Omni Switch/Router User Manual page 1045

Performs a stress test using the internal loopback at the
interface. Packets are generated by the
returned through an internal loopback within the PHY or framer. The
verifies the packets on a bit by bit basis. See the description for stress test
on page 36-8. If Ethernet type switch is tested, this test requires the
file to be in the flash memory.
Tests the Mammoth
CAM
access, and the data line and buffers.
Tests the Mammoth registers and memory. Includes testing the Mammoth
control logic, registers, internal memory, internal cache, external
, and data/address lines.
SRAM
Performs a port test using the internal loopback within the Mammoth
chip. Packet are generated by the
returned through an internal loopback within the Mammoth
verifies the packets on a bit by bit basis.
MPX
Tests the Moriah registers. Test the Moriah control logic, registers, and
data/address lines.
Tests the mammoth
VBUS
Mammoth buffer system, sent out the
Mammoth queues. Data integrity is verified.
Tests the Pseudo
HRE-X CAM
access, and the data line and buffers.
CAM
Functional testing of physical ports with a burst of data packets generated
by the . Packets are generated by the
MPX
looped back through external cables or wrap plugs, and returned to the
. The returned packets are verified bit by bit by the
MPX
requires the use of external cables or wrap plugs. The system will provide
user with instructions for setting up external cables or wrap plugs for port
test and prompts the user for input upon completion of setup. This test can
be bypassed if cables are not available. For more information on port tests,
see Port Tests on page 36-9. For information on cables required for the port
test, see Omni Switch/Router Port Test Wrap Cable/Plug Requirements on
page 36-10 for the Omni Switch/Router.
o Important Note o
For VSD and VSA submodules, the
outside cabling. It is a combination of multiple static
tests for the submodule, rather than a traffic test.
and sent out to the port and
MPX
. Tests the Mammoth
CAM
and sent out to the port and
MPX
circuitry. Frames are generated within the
, and then received on various
VBUS
. Tests the Pseudo
HRE-X
, sent out the physical port,
MPX
test requires no
Running Hardware Diagnostics
or framer
PHY
MPX
control logic,
CAM
,
SDRAM
MAC
chip. The
MAC
control logic,
CAM
. The port test
MPX
Page 36-7