Modifying A Multicast Address Policy - Alcatel Omni Switch/Router User Manual

Modifying a Multicast Address Policy

Modifying a Multicast Address Policy
After you create a multicast
more addresses through the
cast address. Follow the steps outlined in Modifying Multicast VLANs on page 23-9 and the
steps for Adding More Policies for This VLAN on page 23-10. Continue with the procedure
below.
The following menu displays:
1. Press and
2. The following prompt displays:
Indicate whether or not you want to enable this rule. Type
you disable the rule, then the multicast addresses you enter will not be used to flood traf-
fic, but the parameters you set up for the multicast
is different from the Admin Status for the multicast
rule. You can enable or disable the rule at a later time using the
3. The following prompt displays:
Enter one or more multicast addresses. Separate addresses by a space. When you have
entered the final multicast address, leave a space and type
4. The following prompt will display:
You can set up multiple rules for the same multicast
set up more rules in addition to the multicast address rule specified here. If you enter ,
you will be prompted for the next rule that you want to set up on this multicast
you enter , you will receive a message, similar to the one below, indicating that the
multicast
Page 23-12
, you can modify the multicast address policy by adding
VLAN
.
was set up.
VLAN
command. However, you can not add an existing multi-
will be saved. This Admin Status
VLAN
as it controls only this specific
VLAN
. Enter a
VLAN
to enable or to disable. If
command.
.
here if you want to
VLAN
. If