Alcatel Omni Switch/Router User Manual page 170

Configuring the Ethernet Management Port
2) IP Address
Enter an address for the Ethernet management port in dotted decimal or hexadecimal nota-
IP
tion (the default is
address to
at the prompt.
3) Subnet Mask
Enter an subnet mask in dotted decimal or hexadecimal notation (the default is
IP
net Control Message Protocol (
at the prompt.
4) Bcast Address
The default broadcast address is automatically derived from the default
(the default is 192.255.255.255). You can enter a new address in dotted decimal or hexadeci-
mal notation. For example, to change the broadcast address to
at the prompt.
5) Gateway Address
You can enter an
ent net) in dotted decimal or hexadecimal notation. The default is 192.168.1.1. For exam-
IP
ple, to change this address to
at the prompt.
6) Remote Host Address
You can enter an
decimal or hexadecimal notation. The default is 192.168.1.1. For example, to change this
address to
at the prompt.
7) RIP Mode
This parameter is an informational field, which shows that the
cannot modify this parameter.
Page 6-6
). For example, to change the Ethernet management port's IP
, enter
This address must not be on the same subnet as any
IP
other router on the switch.
IP
). If no mask is provided, the switch will try to determine the mask using Inter-
) requests. For example, to change the subnet mask to
ICMP
, enter
address for the first hop router to a remote host (if the host is on a differ-
IP
address for a a remote host (if the host is on a different
IP
, enter
o Note o
, enter
RIP
address class
VLAN IP
, enter
net) in dotted
IP
mode is inactive. You