Viewing Parameters For All Submodules In The Chassis - Alcatel Omni Switch/Router User Manual

KeepAlive Timeout
The number of 100 millisecond increments between generated echo message requests. This
only displays if the port is using PPP as its encapsulation type. The valid range is 0-255.
Loopback Timeout
Sets the transition time between proprietary messages sent over the link. These messages are
analyzed to determine whether the link is in a loopback state. This only displays if the port is
using Frame Relay as its encapsulation type. The valid range is 0-255.
Viewing Configuration Parameters for the WSX
You can view all current parameters for a
command. These parameters will be either the default parameters or parameters you
modified using the
You have a choice of viewing parameters at the chassis, slot or port level. You receive
different configuration choices depending upon which level you choose. The sections below
describe both ways to use the

Viewing Parameters for all Submodules in the Chassis

To view port parameters for all
or
A screen similar to following displays. In this example, the port parameters being displayed
are for a system that contains a 2-port BRI submodule in slot 3.
This screen lists the current values for the listed parameters.
For ,
command. For detailed information on these values, see Modifying a Port on page
28-14. For ,
through the
38.
WSX
command or network management software.
command.
boards in a chassis, enter the following command
submodule
and , these parameters are the same as those set through the
and , these parameters are the same as those set
command. See Obtaining Status and Statistical Information on page 28-
The WAN Port Software Menu
port or an individual virtual circuit using the
Page 28-27