Configuring The Diagnostic Test Environment; Configuring Tests For Ethernet Modules - Alcatel Omni Switch/Router User Manual

Configuring the Diagnostic Test Environment

Configuring the Diagnostic Test Environment
The command allows the user to tailor diagnostic testing characteristics per slot
module. To configure diagnostic tests for a switching module, enter the
followed by the slot number for the module. The slot number is an integer ranging from 1 to
the number of slots in the chassis (3 for 3-slot Omni Switch/Routers; 5 for 5-slot Omni
Switch/Routers and 9 for 9-slot Omni Switch/Routers).
The command allows the user to bypass testing individual slots when running the
command. In addition, the
and port mode for applicable Ethernet modules for tailoring of individual slots during diag-
nostic testing.
No default value is set and input must be provided at the time of entering the command. For
example, to configure applicable diagnostic tests for the switching module in slot 4, enter:
at the system prompt. The following is a typical example.
Note that for all switching modules other than modules, the
the only available one. See Configuring Tests for Ethernet Modules on page 36-17 for informa-
tion on using the
is issued. The default is
The following will then be displayed.
Enter if you want to make this change. If you enter
the following will be displayed.
If you want to cancel this change, enter
the following will be displayed.
Page 36-16
command allows the user to configure the port speed
command with Ethernet modules.
. Allows the user to select to bypass this slot when the
. If you want the command to skip this module, enter
, the change will be made and
and the command will terminate and
command
option is
command