Alcatel Omni Switch/Router User Manual page 780

NetBIOS Relays
Configuring NBDD Relay
If you want to send
To enable the
screen. The screen redisplays similar to the following:
Either a Next-hop Address or a Forward to VLANs value must be configured for the relay.
Next-hop Address
Use this parameter to list, add, or delete the server address(es) to which the
will forward. The default is
configured. Up to 8 addresses may be configured. You can list, add, or delete addresses by
entering ,
Forward to VLANs
Use this parameter to list, add, or delete
This default is
32 may be configured. You can list forwarding
VLANs
forwarding list by entering
asterisk indicate the
Page 26-16
datagrams across networks, you should enable the
NetBIOS
relay, enter at the command prompt of the UDP Relay Configuration
NBDD
This value redisplays as
, or on the command line.
. This value changes to
, , or
to which the relay will forward.
VLANs
when at least one address is
to which the
VLANs NBNS UDP
when at least one
, or add or delete
VLANs
on the command line. Entries marked with an
relay.
NBDD
relay
NBNS UDP
relay will forward.
is configured. Up to
VLAN
from the
VLANs