Configuring Spanning Tree Port Parameters - Alcatel Omni Switch/Router User Manual

Configuring Spanning Tree
Configuring Spanning Tree Port Parameters
The commands allows you to configure port parameters (as opposed to bridge parame-
ters) for spanning tree. To configure port parameters
1. Enter the
where
configure spanning tree port parameters. For example, to configure parameters for Group
1, you would enter:
As a variation of this command, you can enter the
group. This will allow you to configure the port parameters on the currently selected
group. For information on how to select a group, see Selecting a Default Group on page
17-7.
A screen similar to the following is displayed:
2. To modify a parameter, enter the index (row) number, column letter ( , , , , or ), an
equal sign (=), and then the new parameter, as follows.
For example, if you wanted to enable transmit Functional Address (
the slot identified by
Page 17-30
command as shown:
is the number of the group in the switch for which you want to
, then you would enter:
command without specifying a
in column ) for