Setting Configuration Parameters; Modifying A Port - Alcatel Omni Switch/Router User Manual

Setting Configuration Parameters

Setting Configuration Parameters
When you plug in a
board will default the WAN port protocol to frame relay for WSX serial ports, T1 and E1 ports.
Commands generic to the WSX module can be found in Chapter 49.
By default the WSX frame relay software uses
Management Interface (
tion, the access rate defaults to 64 Kbps for RS-232 cables and to 2 Mbps for all other cable
types. You can change these settings as well as several other settings with the
command.
You have a choice of modifying parameters at the port or
receive different configuration choices depending upon which level you choose. The two
sections below describe both ways to use the

Modifying a Port

To modify a port, enter the following command
where
number on the
port number 1 on the WSX board in switch slot 3, you would enter
Page 29-22
board it is automatically configured with default settings. The WSX
WSX
) and uses a Committed Information Rate (
DLCMI
is the slot number where the
board that you want to modify. For example, if you wanted to modify
WSX
or
Annex D for the Data Link Control
ANSI T1.617
(virtual circuit) level. You
DLCI
command.
board is located, and
WSX
) of 0. In addi-
CIR
is the port