Displaying Gmap Statistics By Mac Address - Alcatel Omni Switch/Router User Manual

Alcatel switch/router release 4.5
Hide thumbs Also See for Omni Switch/Router:
Table of Contents

Advertisement

Displaying GMAP Statistics by MAC Address

To display
statistics for all
GMAP
displays similar to the following:
To limit the display, specify the
Fields in this table are defined as follows:
. The
MAC
. The group(s) to which the
. The protocol associated with the group on the switch from which the information
was received. Protocol values are defined as follows:
• e0e0 or ffff — IPX over 802.3
• 8137 — IPX over Ethernet II
• 18137 — IPX over
• 28137 — any IPX encapsulation
• 800 — IP
• 809b — AppleTalk
• 1809b — AppleTalk over
• 6003 —
DECNET
. The
MAC
. The first two bytes are not used. The third byte displays the AutoTracker flags associ-
ated with the entry on the source switch. The last byte displays the router flags associated
with this entry on the source switch.
. The number of seconds remaining until this entry is deleted (unless another
message is received and then the entry is refreshed).
GMAP
addresses, use the
MAC
address. For example:
MAC
address of the local end station.
address belongs.
MAC
SNAP
SNAP
address of the switch from which the entry was received.
command. The screen
Page 21-13
GMAP

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Omni Switch/Router and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents