Using Mpm Commands With Software Release 3.2 And Later - Alcatel Omni Switch/Router User Manual

The MPM Command/Menu
All of the
you have redundant
commands shown below.
All of the

Using MPM Commands with Software Release 3.2 and Later

In Release 3.2 and later, the commands in the
flash directory. Since more than one flash directory can exist, you must indicate which flash
directory you want to use when you access a secondary
you access a primary
prefix and are listed below.
To indicate which flash directory you want to use, enter a slash ( ), the name of the direc-
tory, and another slash ( ) before the file name in all commands that begin with the prefix
. For example, to transfer the
to the primary
at the system prompt.
Page 6-10
menu commands, except for the
. If you are connected to the secondary
MPXs
commands are described in the sections that follow.
from a secondary
MPX
when you have logged into the secondary
MPX
o Important Note o
In the current release, you must indicate the name of
the flash directory in commands that begin with the
prefix even if you have just one flash directory on
both .
MPXs
and commands, function only if
MPX
menu support the use of more than one
from a primary
MPX
. All of these commands begin with the
MPX
file from the directory on the secondary
, enter
MPX
, type a to list the
and when
MPX
MPX