Module Connection Errors - Alcatel Omni Switch/Router User Manual

Error Messages
Message
xxx xx
xxx
Message
xxx xxx
Page 35-12
Serial Port Configuration Errors
Corrective Action
Reboot the system, then use the Boot Line configuration to
force SLIP down at the boot line (refer to Appendix A "The
Boot Line Prompt").
Reconnect the SLIP line; reconfigure using the
xxx
Check the remote IP address by using the
xxx
the UI. Refer to Chapter 6, "Configuring Management Processor
Modules."
xxx Reboot the switch.

Module Connection Errors

Corrective Action
If this message shows up once or twice, it probably means that
xxx
someone is plugging a new cable in slot/port xxx/xxx, physical
connector xxx. If it displays more frequently, then there is
probably a bad CDDI or FFDI connection on slot/port xxx/xxx,
physical connector xxx, caused by either dirty connectors or
bad cabling. Try cleaning the connections or replacing the
cabling.
command.
command at