Adding A Virtual Circuit - Alcatel Omni Switch/Router User Manual

Adding a Virtual Circuit

Adding a Virtual Circuit
Data virtual circuits and their
Frame Relay network. However, it may be convenient to pre-configure these virtual circuits
before connecting to a live network. In such a case you will need to use the
to set parameters for the virtual circuit. The information for the virtual circuit will be stored in
the database. This method of configuration is different than using the
WSX
which changes virtual circuit parameters after the circuit has been learned from the network
or configured through
To set up a data virtual circuit, enter the following command
where
the board, and
WSX
add. For example, if you wanted to add
you would enter
A screen similar to the following displays:
Enter the value for each parameter after the colon prompt (:). An additional field,
, is displayed if you do not specify a DLCI number in the
ing parameters are the same ones used for the
Circuit on page 29-29 for information on each of these parameters.
When you have entered values in all fields, the following prompt displays
Enter a to set up additional virtual circuits or enter
enter , then you are prompted for all virtual circuit parameters again.
Page 29-32
s are normally learned through status messages with the
DLCI
.
is the slot number where the
is the number used to identify the virtual circuit that you want to
or
board is located,
WSX
32 on Port number 1 of the
DLCI
command. See Modifying a Virtual
to exit the
command
command,
is the port number on
board in slot 2,
WSX
command. The remain-
command. If you