Alcatel Omni Switch/Router User Manual page 921

DLCI Layer Information
The information in this section of the display provides statistics on virtual circuits. Each row in
this table corresponds to one virtual circuit.
DLCI Num
The number assigned to this virtual circuit. This value is only valid locally; the same
DLCI
virtual circuit on the other end of the Frame Relay line may or may not use the same
for this VC.
Admin/Oper Status
This field shows the Administrative and Operational Status of this
indicator before the slash refers to the Administrative Status. If
has been enabled and can transmit data as long as its Operational Status is also UP. If the
Administrative Status is
is good.
The status indicator after the slash refers to the Operational Status. If
circuit is capable of passing data. If
network has declared the virtual circuit inactive, the network does not respond to
messages, or the
ENQUIRY
DLCI Type
The type of virtual circuit will be either
is a management, or control, circuit that is used by Frame Relay protocols, such as the
protocols, to pass various status messages. The Frame Relay network does not self-
DLCMI
configure management virtual circuits. Data VCs can become "configured" if you use
to change any of the default settings for the Data VC. Learned means this is a
Data VC that the Frame Relay network informed the
messages (using a Control VC).
The
always
not dynamically configure management virtual circuits.
Frames In
The number of frames received on this VC since it was created.
Frames Out
The number of frames transmitted on this VC since it was created.
Octets In
The number of octets, or bytes, received on this VC since it was created.
Octets Out
The number of octets, or bytes, transmitted on this VC since it was created.
, then the VC will not pass data even if its physical connection
, then the
VC
is Administratively Down.
VC
Note
of the management
DLCI
since the Frame Relay network does
Obtaining Status and Statistical Information
virtual circuit
, then the virtual circuit
, then the virtual
UP
cannot pass data because the
or . Configured means this VC
module about through status
WSX
(0 or 1023) is
DLCI
. The status
STATUS
Page 29-49