Alcatel Omni Switch/Router User Manual page 628

Defining and Configuring AutoTracker Policies
Set Up an IPX Address
a. To specify an
b. The following prompt displays:
Enter an
mobile group or AutoTracker
can enter a minimum of one hex digit in this field. If you enter less than eight hex
digits, the system prefixes your entry with zeros to create eight digits. All devices with
the specified network number will be included in the mobile group or AutoTracker
.
VLAN
c. The following prompt displays:
Select the encapsulation type from the list.
number at bootup. Typically,
using different encapsulation types within the same physical network. When an
encapsulation type is specified here, an
number at bootup will be assigned to the mobile group or AutoTracker
as the device uses the encapsulation type you specify here.
d. Go on to Step 4 below.
4. The following prompt displays:
You can set up multiple rules for the same mobile group or AutoTracker
here if you want to set up more rules in addition to the Network Address rule specified
here. If you enter , you will be prompted for the next rule that you want to set up on
this mobile group or AutoTracker
to configure that rule.
If you enter , you will receive a message, similar to the one below, indicating that the
was set up.
VLAN
You are done setting up rules for this mobile group or AutoTracker
Page 20-12
address, enter a
IPX
network number to define the network devices you want included in the
IPX
VLAN
IPX
VLAN
at the
. addresses consist of eight hex digits and you
IPX
devices do not know their network
IPX
servers assign different network numbers to devices
device that does not know its network
IPX
. Follow the directions in the appropriate section
prompt.
as long
VLAN
. Enter a
VLAN
VLAN.