The Filter Command - Alcatel Omni Switch/Router User Manual

Alcatel switch/router release 4.5

Hide thumbs Also See for Omni Switch/Router:

Table of Contents

The Filter Command

The Filter command filters unwanted information from a

lines containing a specified text pattern (up to 80 characters). Once the Filter command has

been executed, the Filter mode remains active until the end of the

or until the user exits the current

Like the Search command, the Filter command cannot be limited to a specific column or

To use the Filter command, type at the

displayed in the

table, then press

The Filter command is case sensitive. When using this

command, be sure to type the text pattern exactly as it

would appear in the

Real World Example

The following example uses the Filter command to display only those lines containing Lane

services in the

table. (Before using this example, be sure that the

and the default is set at 22 lines. For more information, refer to page 4-38.)

Note that, because the information in the table exceeds the

prompt appears at the bottom of the screen.

UI Table Filtering (Using Search and Filter Commands)

prompt, followed by the text pattern you want

o Important Note o

. A table similar to the following will be displayed:

table by displaying only those

table has been reached,

mode is enabled

command's default of 22

Show Quick Links

Table of Contents

Do you have a question about the Omni Switch/Router and is the answer not in the manual?