Viewing Total Remote Statistics; Viewing T1 Remote Statistics - Alcatel Omni Switch/Router User Manual

Viewing T1 Remote Statistics

Viewing T1 Remote Statistics
To receive and monitor remote statistics on T1 ports you must enable the Facility Datalink
( ) protocol through the
FDL
not enable
FDL

Viewing Total Remote Statistics

You can view remote statistics occurring during the past 24 hours on a single port by enter-
ing the following command
where
the board on which you want to view statistics. For example, to view remote 24-hour statis-
tics for Port 2 on the board in slot 5, enter
A screen similar to the following displays:
Most of the definitions of the fields and columns in this display are the same as those used for
the command. See Viewing Total Local Statistics on page 33-17 for an explanation of
these statistics. The remaining statisitics are described below.
. Loss of Frame Count. A loss of frame count is the accumulation of the number of times
a "Loss of Frame" is declared.
Page 33-20
command. These statistics will not be available if you do
.
Because there is no
tions, remote statistics are not supported on E1 ports.
is the slot number where the board is located, and
Note
standard for E1 configura-
FDL
is the port number on