Running Frame Fabric Tests On Omni Switch/Routers - Alcatel Omni Switch/Router User Manual

Running Frame Fabric Tests on Omni Switch/Routers

Running Frame Fabric Tests on Omni Switch/Routers
You can test the Omni Switch/Router
of every switching module with the
ASIC
as follows:
The
0 to 999. If you enter , the
Using the
physical port of every switching module in the chassis. The external cables or wrap plugs
used in this test are identical to the one listed in the full duplex port test. See Omni
Switch/Router Port Test Wrap Cable/Plug Requirements on page 36-10 for more information.
The option, which can be used with the
back. Using this option performs the
plugs.
The chassis should be fully loaded (i.e., Omni Switch/Router modules in all slots) to achieve a
thorough testing of both the frame fabric
addition, an
MPX
To execute the framefab test indefinitely, for example, enter
at the system prompt. A screen similar to the following will be displayed.
Page 36-18
Multi VBUS
option lets you set the number of times to run the test, which can be from
test will continue indefinitely. If you do not use the
option, then the
option requires the use of external cables or wrap plugs for the first
should be installed in Slot 1.
— Output continues on next page —
( ) backplane and the frame fabric
MVBUS
command. The syntax for this command is
test will be executed once.
option, performs an internal loop-
test without the use of external cables or wrap
and the Omni Switch/Router backplane. In
ASICs