Defining A Protocol Policy - Alcatel Omni Switch/Router User Manual

Defining and Configuring AutoTracker Policies
Defining a Protocol Policy
After you enter the Administrative Status for this mobile group or AutoTracker
following menu displays:
1. Press and press
2. The following prompt displays:
Indicate whether or not you want to enable this rule. Type
you enable the rule, the mobile group or AutoTracker
membership of devices. If you disable the rule, then this rule will not be used in assign-
ing devices, but the parameters you set up will be saved. The Admin Status for a Policy is
different from the Admin Status for the mobile group or AutoTracker
only to this specific rule. You can enable or disable the rule at a later time using the
command.
3. The following prompt displays:
Enter the number for the protocol that will be used to define this mobile group or
AutoTracker
protocol, you are indicating that all traffic originating from network devices using that
protocol will be assigned to this mobile group or AutoTracker
, ,
IP IPX DECNET
Page 20-8
.
. Numbers are listed next to the protocol names. By selecting a specific
VLAN
, and protocols by entering 1, 2, 3, or 4, respectively.
APPLETALK
o Please Take Note o
(address resolution protocol) is included as
ARP
(datagram delivery protocol) and
DDP
Talk ) are included as AppleTalk.
ARP
Phase IV traffic only.
DECNET
VLAN
to enable or to disable. If
will use it to determine
VLAN
as it controls
VLAN
. You can select the
VLAN
.
IP
(Apple-
AARP
is
DECNET
, the