Ethernet Management Ports And Redundant Management Processor Modules - Alcatel Omni Switch/Router User Manual

Ethernet Management Ports and Redundant
Management Processor Modules
If redundant both have Ethernet management ports (
MPXs
have the same address if automatic file synchronization is enabled. If both
IP
plugged into the same subnet, the
network.
To get around this duplicate
tion and then you must configure different IP addresses for the two
the following steps:
1. On the primary management module, enter
at the system prompt. (See Setting Automatic Config Synchronization on page 6-15 for
more information on the
2. If automatic file synchronization is already disabled, simply press
enter at the prompt.
3. Enter
at the prompt. (See Configuring the Ethernet Management Port on page 6-5 for more
information on the
4. Enter followed by the
5. Enter
at the prompt to save the
6. Enter
at the prompt to make the primary management module the secondary module and the
secondary module primary.
7. Log into the now primary management module.
8. On the now primary management module, enter
at the system prompt.
9. If automatic file synchronization is already disabled, simply press
enter at the prompt.
10. Enter
at the prompt.
11. Enter followed by the

Ethernet Management Ports and Redundant Management Processor Modules

will show that there are duplicate
UI
address problem, you must disable automatic file synchroniza-
IP
command.)
command.)
address for the
IP EMP
address.
IP
address for the
IP EMP
), both
EMPs EMPs
addresses on the
IP
. To do this, perform
EMPs
on the primary management module.
on the management module.
in the switch will
are
EMPs
. If it is enabled,
. If it is enabled,
Page 6-7