Adding A User Account Using The Cli Command Mode; Assigning Account Privileges Using The Cli Command Mode - Alcatel Omni Switch/Router User Manual

Adding a User Account Using the CLI Command Mode

To add a user account from the
trative privileges. Enter the following at the command prompt.
user_name
where user_name is the new user login account name and user_password is the new user
login account password. Both these values are specified by the user. For the user name
"Techpubs1", the following message is displayed:
If you do not specify a password when you create the new account,
default password.
It is recommended that you change the password from
the default for all login accounts.
Both the user account name and the password are limited to 16 text characters. The new
login account and password will take effect at the user's next login session.

Assigning Account Privileges Using the CLI Command Mode

A user account's
READ
subsets of commands. The command subsets referred to as command families are shown
here:
and
In addition to assigning privileges according to command families, an administrator can
restrict the user account's ability to execute specific commands. Here is a list of commands
that can be restricted from a user account.
If partition management is intended for a user account,
that account cannot have permission to use the
command or the
mode, you must be logged into an account with adminis-
CLI
user_password
o Noteo
and privileges can be assigned for all commands or for various
WRITE
.
and .
o Warningo
mode.
UI
Managing User Login Accounts
becomes the
UI
Page 8-13