Alcatel Omni Switch/Router User Manual page 623

Defining a MAC Address Range Policy
After you enter the Administrative Status, the following menu displays:
1. Enter and press
2. The following prompt displays:
Indicate whether or not you want to enable the Administrative Status for this rule. Type
to enable or to disable. If you enable the rule, the switch will use it to determine
membership of devices. If you disable the rule, then the switch will not use this rule, but
the parameters you set up will be saved. The Admin Status for a Policy is different from
the Admin Status for this mobile group or AutoTracker
specific rule. You can enable or disable the rule at a later time using the
command.
3. The following prompt displays:
Enter the low end
addresses by a space. The range is specified using the last two bytes of the MAC address.
When you have entered the high end
4. The following prompt displays:
You can set up multiple rules. Enter a
to the Address rule specified here. If you enter , you will be prompted for the next
MAC
rule that you want to set up. Follow the directions in the appropriate section to configure
that rule.
If you enter , you will receive a message, similar to the one below, indicating that the
mobile group or AutoTracker
You are done setting up rules.
MAC range rules only apply to moblie groups. They
cannot be configured for AutoTracker VLANs.
.
address followed by the high end MAC address. Separate
MAC
MAC
here if you want to set up more rules in addition
was set up.
VLAN
o Note o
Defining and Configuring AutoTracker Policies
as it controls only to this
VLAN
address press .
Page 20-7