Alcatel Omni Switch/Router User Manual page 629

Alcatel switch/router release 4.5
Hide thumbs Also See for Omni Switch/Router:
Table of Contents

Advertisement

Defining Your Own Rules
A user-defined rule enables you to include all devices in the mobile group or AutoTracker
that originate frames containing a specified pattern at a specified location. Each user-
VLAN
defined rule requires an Offset, a Value, and a Mask; you will be prompted for each of these
values. The Offset specifies the location of the pattern within the frame. The Value specifies
the pattern. The Mask specifies the bits that you care about within the Value pattern.
After you enter the Administrative Status for this mobile group or AutoTracker
following menu displays:
1. Enter
and press
2. The following prompt displays:
Indicate whether or not you want to enable the Administrative Status for this rule. Type
to enable or
to disable. If you enable the rule, the switch will use it to determine
membership of devices. If you disable the rule, then the switch will not use this rule, but
the parameters you set up will be saved. The Admin Status for a Policy is different from
the Admin Status for the mobile group or AutoTracker
specific rule. You can enable or disable the rule at a later time using the
command.
3. The following prompt displays:
Enter an
value, in number of bytes, to define the location where the
pattern – is found. The offset value can be any number from 0 – 63. The first byte of the
frame's
header is considered byte 1. An offset of 0 specifies that the pattern begins in
MAC
byte 1 of the frame.
As an example, enter an offset value of
, because that pattern begins in the 21st byte of the frame.
NETBIOS
4. The following prompt displays:
Enter a
, in hex, to specify the pattern itself. The value can be a maximum of eight
bytes. For example, enter
5. The following prompt displays:
Enter a
value, in hex, to specify the bits within the
mask can be a maximum of eight bytes, but must be the same length as the
entered. The mask value is
Defining and Configuring AutoTracker Policies
.
if you want to specify the pattern that defines
to specify the pattern that identifies
ed with the
and frames are searched for the result.
AND
VLAN
as it controls only to this
VLAN
.
NETBIOS
that you care about. The
, the
– or
you
Page 20-13

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Omni Switch/Router and is the answer not in the manual?

Table of Contents