Alcatel Omni Switch/Router User Manual page 679

Step C. Configuring the Virtual Router Port (Optional)
You can now optionally configure the virtual router port that this
cate with other AutoTracker
switch. If you do not define a virtual router port for this
only be able to communicate with devices in other
You will have the choice of configuring
steps below:
1. After you finish configuring AutoTracker Policies for this
displays:
Press if you want to enable IP Routing on this virtual router port. If you do not
enable IP, then this
set up the IP router port, enter , press
You may enable routing of both
this router port. If you set up dual-protocol routing, you
must fill out information for both
ters.
2. The following prompt displays:
Enter the IP address for this virtual router port in dotted decimal notation or hexadecimal
notation (e.g., 198.206.181.10). This IP address is assigned to the virtual router port for
this . After you enter the address, press
VLAN
3. The following prompt displays:
The default IP subnet mask (in parentheses) is automatically derived from the
address class. Press
in dotted decimal notation or hexadecimal notation and press
4. The following prompt displays:
The default IP broadcast address (in parentheses) is automatically derived from the
IP address class. Press
address in dotted decimal notation or hexadecimal notation and press
5. The following prompt displays:
Enter a useful description for this virtual IP router port using alphanumeric characters. The
description may be up to 30 characters long. Press
6. The following prompt displays:
Indicate whether you want to disable routing in the
through the
s. A virtual router port for the
VLAN
,
IP IPX
will not be able to internally route IP data. If you don't want to
VLAN
Note
to select the default subnet mask or enter a new subnet mask
to select the default address or enter a new IP broadcast
command.
VLAN
is created within the
VLAN
, devices within the
VLAN
s through an external router.
VLAN
, or both and routing. Continue with the
IP IPX
, the following prompt
VLAN
and skip to Step 10.
and traffic on
IP IPX
and parame-
IP IPX
.
.
. You can enable routing later
VLAN
Creating AutoTracker VLANs
will use to communi-
will
VLAN
's IP
VLAN
.
's
VLAN
.
Page 22-19