Running Diagnostics - Alcatel Omni Switch/Router User Manual

•
•
•
•
•
•
•
•
•
•

Running Diagnostics

You must log in to the
the and command.
There are several image files used for hardware diagnostics. These files have the following
uses:
•
•
To function properly, hardware diagnostics must be run
offline (i.e., the switch should not be connected to a
network) or during network downtimes. In addition,
spanning tree must be set to
For details on using the
"Configuring Bridging Parameters."
The of the module under test will be set to red if a failure is detected by diagnostic
OK2 LED
testing. The
OK2 LED
Diagnostics may not run if the
tions. In addition, some diagnostics may affect the settings in configuration files. Therefore,
any customized
completed, these files should be restored and the chassis rebooted prior to normal operation.
The default
1. Remove these files from flash memory by renaming the files to names besides
and . For example, you can rename
that it is the original version of the file.
2. Delete the
3. Reboot the system. The MPX will create default
files are missing from flash memory. These default files are the ones to be used with diag-
nostic software.
Page 36-2
Mammoth Test
VBUS
Pseudo Test
CAM
Port Traffic Test
Port Stress Test (available for Ethernet modules)
Submodule Local Memory Test
Register Test
SUNI
Telluride Register Test
Whistler Register Test
Cable Connection Test
WSX
Alcatel Off-Board Test
CAM
account to access the hardware diagnostics functionality or use
Omni Switch/Router diagnostics image file
Omni Switch/Router stress test image file
o Note o
can be restored by resetting the module or by rebooting the chassis.
and
and files should be saved prior to testing. Once testing is
and files are obtained by performing the following steps:
and files from flash memory.
via the command.
command, see Chapter 17,
files are not in their default configura-
to
and
to highlight the fact
files when these