Adding Isdn Call Links - Alcatel Omni Switch/Router User Manual

Adding a WAN Link
Administrative Status
Sets the Administrative Status of this WAN Link. The options are "
this link and "
Link Type
Specifies the type of physical connection that will carry the link. The options are "
which means a serial or Fractional T1/E1 connection and "
will be used to make the connection.
Link Slot
Specifies the switch slot number to be used by this WAN Link.
Link Port
Specifies the switch port number to be used by this WAN Link.
2. To make a change to the values for any of the fields on this screen, enter the field's line
number followed by the desired value.
3. To add the link for a WSX port, you must specify which switch port and slot is to be
used. To do so, you must make changes to the values for items 4 and 5. For example, if
your WSX port is in slot 5, port 2, you would enter the following three commands:
After entering the

Adding ISDN Call Links

1. To create a link over ISDN, you must enter a Peer ID number (associated with a "PPP
Entity") with the command. See Chapter 30, Point-to-Point Protocol, for details on creat-
ing Peer IDs.
For example, to create a link for Peer ID 1, you would enter the following command
(where
A screen similar to the following displays:
Page 31-4
" which will disable the link but not delete it.
command, you will be returned to the system prompt.
is the Peer ID number):
" which will enabled
" which means an ISDN call
"