Alcatel Omni Switch/Router User Manual page 871

The section devoted to compressed data traffic statistics
will be displayed only if the port has been configured
for STAC-LZS compression.
For detailed descriptions of the fields, refer to Chapter 30, "Point-to-Point Protocol."
Configuring 31 Timeslots on a WAN E1 Port
On E1 ports, the unframed format is not supported since
WSX
framing for PPP or Frame Relay (the "unframed" format is only supported for unstructured
Circuit Emulation T1 or E1 ports).
types (E1, E1-CRC, E1-MF, E1-MF-CRC) with the
T1 and E1 Ports," for more information on the
Most E1 services only allow a maximum of 30 usable timeslots since timeslot 0 is always used
for Frame Synchronization (which is why you cannot use unframed for Frame Relay or PPP
ports since you must specify how timeslot 0 is used) and timeslot 16 is usually used for
multiframe sequencing.
The can support 31 timeslots for cases where timeslot 16 is not used for multiframe
WSX
control. When you configure the timeslots for a
followed by a number of timeslots by using the
page 28-14 for more information on the
Normally, the will use a default configuration that skips timeslot 16 automatically. In this
WSX
way, it will select the E1 frame to generate E1 timeslot 0 (the "synchronization" timeslot), but
leave timeslot 16 (the "multiframe control" timeslot) free. The WAN port configuration
software when configured for 31 timeslots will then use all timeslots from 1 to 31 to give you
a full E1 where timeslot 16 is also used for data. Again, this should only be done for facilities
that do not require E1 Multi-Frame. For those types of E1 lines, they can support a maximum
of 30 timeslots. Only those E1 lines that do not require E1 multiframe can be configured in
the method described below.
To configure a WAN E1 port for 31 timeslots, follow the steps below:
1. Enter
module with the E1 port and
configure E1 port 4/2, enter
WSX
2. Enter at the prompt to set the frame type to E1 or enter
frame type to E1-CRC.
3. Enter
at the prompt to save your settings.
4. Enter
slot number of the module with the E1 port and
For example, to configure
for of .)
5. Enter to set the starting timeslot to 1.
6. Enter
to set the number of timeslots to 31.
7. Enter at the prompt to save your settings.
o Note o
E1 ports must be set to one of the standard E1 Framing
WSX
WSX
command.)
at the system prompt, where
is the port number of the E1 port. For example, to
.
or at the system prompt, where
E1 port 4/2, enter
WSX
The WAN Port Software Menu
s only support standard E1
WSX
command. (See Chapter 33, "Managing
command.)
E1 port, you specify a starting timeslot
command. (See Modifying a Port on
is the slot number of the
at the prompt to set the
is the port number of the E1 port.
. (Note: is the abbreviated
is the
Page 28-45