Modifying An Isdn Configuration Entry - Alcatel Omni Switch/Router User Manual

Modifying an ISDN Configuration Entry

Modifying an ISDN Configuration Entry
The command is used to modify the parameters for a selected ISDN port. These param-
eters are typically provided by the telephone carrier or other service provider at the time the
ISDN line is installed.
1. To modify a specific port, for example in Slot 4, Port 1, enter the following command:
A screen similar to the following displays:
The fields on this screen have the following meanings:
Switch Type
Specifies the type of switch to which this ISDN port is to be connected. The options are:
AT&T 5ESS (
Euro-ISDN ETS 300/British Telecom NET3 (
B1/B2 Signalling Calling Address
The number assigned to this channel by the carrier. If only one address is supplied by the
carrier, assign it to channel B1, and leave channel B2 empty.
B1/B2 Service Profile Identifier (SPID)
The Service Profile Identifier assigned to this channel by the carrier. Normally, this value
contains the calling address surrounded by some digits. If only one address is supplied by the
carrier, assign it to channel B1, and leave channel B2 empty.
Page 32-4
), Northern Telecom DMS100 (
Important Note
When changing the
s, reboot the switch to implement the changes.
), National ISDN-1 Bellcore (
).
or adding/deleting
), and