Alcatel Omni Switch/Router User Manual page 638

Defining and Configuring AutoTracker Policies
Defining a DHCP MAC Address Range Policy
You can see how DHCP MAC address policies were used in an application example on page
20-27.
After you enter the Administrative Status for this mobile group or AutoTracker
following menu displays:
1. Enter and press
2. The following prompt displays:
Indicate whether or not you want to enable the Administrative Status for this rule. Type
to enable or
membership of devices. If you disable the rule, then the switch will not use this rule, but
the parameters you set up will be saved. The Admin Status for a Policy is different from
the Admin Status for the mobile group or AutoTracker
rule. You can enable or disable the rule at a later time using the
3. The following prompt displays:
Enter the low end DHCP
Separate addresses by a space. The range is specified using the last two bytes of the MAC
address.
When you have entered the high end
4. The following prompt displays:
You can set up multiple rules for the same mobile group or AutoTracker
here if you want to set up more rules in addition to the port rule specified here. If you
enter , you will be prompted for the next rule that you want to set up. Follow the direc-
tions in the appropriate section to configure that rule.
If you enter , you will receive a message, similar to the one below, indicating that the
was set up.
VLAN
You are done setting up rules for this mobile group or AutoTracker
Page 20-22
.
to disable. If you enable the rule, the switch will use it to determine
address followed by the high end DHCP MAC address.
MAC
MAC
o Note o
MAC range rules only apply to moblie groups. They
cannot be configured for AutoTracker VLANs.
as it applies only this specific
VLAN
address press .
, the
VLAN
command.
. Enter a
VLAN
.
VLAN