Alcatel Omni Switch/Router User Manual page 865

Intf Type
This column indicates the physical cable type connected to this port. This cable type is
automatically sensed by the
it is or . The following values may appear in this column:
DCE DTE
• (V.35 DTE cable)
• (V.35 DCE cable)
• (RS-232 DTE cable)
• (RS-232 DCE cable)
• (X.21 DTE cable)
• (X.21 DCE cable)
• (RS-530 or RS-449 EIA DTE cable)
• (RS-530 or RS-449 EIA DCE cable)
•
•
The sees and
WSX RS-530
However, this does not affect the operation of either cable type. Both
cables are supported.
If no cable is connected to a universal serial port, then this column will display:
If an error has been detected on the port (e.g., cable type could not be detected), the
following value displays:
Admin/Oper State
This column shows the Administrative and Operational State of this
before the slash refers to the Admin Status. If
data as long as its Operational State is also
pass data even if its physical connection is good.
The value after the slash refers to the Operational State. If
data as long as it has been logically enabled at the Administrative level. If
pass data due to a problem in the physical connection (e.g., cable disconnected,
not detect cable type) or because the port is administratively down. If the Operational State
displays , the port is currently in Loopback (test) mode.
Protocol
The protocol type can be set to either Frame Relay or Point to Point Protocol (PPP).
hardware. This column indicates the cable type and whether
WSX
cables the same because they are electrically identical.
RS-449
, the port has been enabled and can transmit
. If the Admin Status is
The WAN Port Software Menu
and
RS-530 RS-449
port. The value
WSX
, the port will not
, the port is capable of passing
, the port cannot
WSX
Page 28-39
could