Table of Contents
Advertisement
Checking the Flash File System
Checking the Flash File System
The
command performs a file system check of flash memory, which consists of the flash
file system. All image files are stored in flash memory and loaded into system memory when
the switch boots up.
The command also provides diagnostic information in the event of file corruption. To perform
a file system check of flash memory, enter
at the system prompt. A screen similar to the following will be displayed:
If the
command detects a problem with the flash file system, a message will be displayed
indicating the problem, along with any steps needed to resolve it.
Each logical file system must be checked independently.
Page 7-14
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Omni Switch/Router and is the answer not in the manual?