Alcatel Omni Switch/Router User Manual page 1059

2) Stop on Failure
Enter to halt diagnostics in an active state when a failure occurs or
diagnostics and display the
command output. Setting this field to
However, setting this field to
3) Port Test Bypass
Enter to complete testing of all ports regardless of port test failures or
testing at the first port failure. Setting this field to
lems.
4) Port Test Type
Enter (the default) for a port test,
for an stress test. External cables are required for the port and stress tests but not for the
ILB
test. In addition, the stress test requires a special image file (see Running Diagnostics on
ILB
page 36-2) and is only available for Ethernet (
Switch/Router.
Option 5,
Switch/Router only.
5) HRE-X Test Mode
This option lets you configure port tests for
ing modules. It does not affect the port test for
test on installed on switching modules runs in conjunction with the normal port test.
HRE-Xs
Each physical port is tested with the normal port test path and then through the
test path before testing the next physical port. Subsequent physical ports are tested with only
the normal port test path.
Enter to bypass testing of the
described above.
and
can be used to further troubleshoot problems.
requires more user intervention during a test.
can be used to further troubleshoot prob-
for an Internal Loopback (
and
ESX GSX
o Note o
, is for the Omni
installed on Omni Switch/Router switch-
HRE-Xs
installed on
HRE-Xs
when the port test is run or
HRE-X
Running Diagnostics on an Entire Chassis
(the default) to exit
sections of the
(the default) to stop
) test, for a stress test, or
ILB
) modules on the Omni
. Currently, the port
MPXs
HRE-X
to perform the test as
port
Page 36-21