Wan Modules; Wan Pinouts - Alcatel Omni Switch/Router User Manual

WAN Modules

WAN Modules
The Omni Switch/Router currently supports the following Wide Area Network (
modules:
•
WSX-S-2W
•
WSX-SC
•
WSX-FT1/E1-SC
•
WSX-BRI-SC
All of these modules are described and illustrated in the sections beginning on page 3-27.
A switching module is actually a submodule, or daughtercard, that attaches to an Omni
WSX
Switch/Router High-Speed Module (
software image files,
for storing
MAC
module that connects to the switch's backplane.

WAN Pinouts

The figures and tables on the following pages illustrate the pinouts used on Omni
Switch/Router
back" ( ) is not supported on the
LL
page 3-25). In addition, CTP2, CTP1, and CTP0 are assigned to CS(B), DR(B), and CD(B),
respectively, on the serial port. The later are not used in the cable configurations that require
the former.
See Appendix B, "Custom Cables," for information on cables used to connect the serial
connector to different interface types.
Page 3-22
Provides two serial ports that support Frame Relay or
Provides four or eight serial ports that support Frame Relay or
with data compression
ne or two
Provides o
support Frame Relay or
ne or two Universal Serial Ports (
Provides o
ports that support Frame Relay or
ISDN-BRI
HSX
for performing switching, and Content Addressable Memory (
ASICs
addresses. You plug your cable into the
modules. Please note that the signal commonly knows as "remote loop-
WAN
WAN
.
/ ports and one or two serial ports that
T1 E1
PPP with data compression
). The contains
HSX RISC
submodule, but it is the
WSX
serial port (see WAN Serial Port Specifications on
)
WAN
.
PPP
PPP
.
) ports and one or two
USPs
PPP with data compression
processors, for holding
RAM
CAM
HSX
.
)